Improved models of failure time for atmospheric tanks under the coupling effect of multiple pool fires

Fire accidents of chemical installations may cause domino effects in atmospheric tank farms, where a large amount of hazardous substances are stored or processed. Pool fire is a major form of fire accidents, and the thermal radiation from pool fire is the primary hazard of domino accidents. The coupling of multiple pool fires is a realistic and important accident phenomenon that enhances the propagation of domino accidents. However, previous research has mostly focused on the escalation of domino accidents induced by a single pool fire. To overcome the drawback, in this study, the failure of a storage tank under the coupling effect of multiple pool fires was studied in view of spatial and temporal synergistic process. The historical accident statistics indicated that the accident scenario of two-pool fires accounted for 30.6% in pool fires. The domino accident scenario involving three tanks is analyzed, and the typical layout of tanks is isosceles right triangle based on Chinese standard “GB50341-2014”. The thermal response and damage of a target tank heated by pool fires were numerically investigated. The volume of 500 m³, 3000 m³, 5000 m³ and 10000 m³ were selected. Flame temperature was obtained by FDS, and then was input onto the finite element model. The temperature field and stress field of target tanks were simulated by ABAQUS. The results showed that the temperature rise rate of the target tanks under multiple pool fires was higher than that under a single pool fire. The failure time of the tank under the coupling effect of multiple fires was lower than that under the superposition of multiple fires without the first stage. The stress and yield strength were compared to judge the failure of the target tank. The model of failure time for the tank under the coupling effect of pool fires was established. Through the verification, the deviation of this model is 4.02%, which is better than the deviation of 15.76% with Cozzani's model.     

油品装卸过程静电特性研究

为了研究油品装卸过程中的静电危险性,在两个城市的油库和加油站对油品的装油、卸油过程,以及装油的油罐车从油库向加油站行驶的过程中,油罐车内油品的油面电位进行了静电检测。通过对大量油罐车内油面电位的检测数据分析可以看出,在正常装卸油过程中,油罐车内油品的油面电位远远小于标准所规定安全油面电位,有缩短稳油时间的可能性。     

1987-2006年厦门市土地利用变化检测分析

通过对厦门市五个时相的土地利用变化检测,分析了厦门市1987年-2006年间各分区的土地利用变化及各地类在各年间的变化情况,并分析其变化原因.     

Effect of working time on environmental pressures: empirical evidence from EU-15, 1970–2010

There is growing interest in the correlation between working time and environmental pressures, but prior empirical studies mostly focused on static methodologies. This article used dynamic panel regression approaches to examine and compare the relationship among western, southern, and northern European countries over the period 1970–2010, and proved the existence of strongly significant relationships in all models. Furthermore, this article detected the relationship between working hours and environmental indicators (carbon emission and energy use) at different phases. We contribute to a further understanding of the environmental effects of the working time reduction policy by comparing the differences among various periods and country groups in a system generalized method of moments (GMM) dynamic framework.     

胞外聚合物磷酸盐形态对生物除磷过程的影响研究

以不同DO条件下污泥龄(SRT)分别为10 d和30 d的两组实验室A/O-SBR反应器活性污泥为研究对象,探讨了胞外聚合物(EPS)磷酸盐形态对生物除磷过程的影响.结果表明,污泥絮体中的磷主要分布于EPS中,PO3-4-P和聚磷酸盐(Poly-P,包括低分子量聚磷酸盐LMW PolyP和高分子量聚磷酸盐HMW Poly-P)是EPS磷的主要形态;EPS对生物除磷的影响明显大于细菌细胞,EPS磷的厌氧降低量和好氧升高量为胞内磷变化量的2.8~6.4倍.EPS中的LMW Poly-P和HMW Poly-P含量均表现厌氧降低和好氧升高的变化规律;对于相同SRT的污泥,中DO(2.5~3.5 mg·L-1)条件较低DO(0.7~1.0 mg·L-1)条件下EPS的LMW Poly-P和HMW Poly-P有更大的厌氧降低量和好氧升高量,对应着更明显的生物除磷过程,说明EPS不仅是生物除磷过程的中转站,而且参与了生物聚磷过程.     

不同方法测定水体总氮存在的问题探讨及条件优化研究

利用碱性过硫酸钾消解紫外分光光度法,探讨了消解时间和消解温度对空白吸光值的影响,认为增加消解时间可以降低空白吸光值,而提高消解温度对空白吸光值的影响不大;对于某些样品中总氮含量低于氨氮含量的现象,将碱性过硫酸钾装入小试管,再放入装有水样的比色管中,虽然能够减少氨气形式逸出的氮含量,但回收率较低;连续流动和流动注射-盐酸萘乙二胺分光光度法,在以后的修订中应增加过硫酸钾含氮量以及镉柱还原能力大小的界定.     

水和废水中化学需氧量测定方法的改进研究

在水的CODcr测定中,将30 ml回流量确定为常规检测回流量,可节省浓硫酸和硫酸银用量50%;将消解回流时间从120 min缩短为30 min,已满足对地表水和各类废水中CODcr的准确测定,可节省水电费用75%以上,含氯水样中Cl-的掩蔽研究表明:按国标法用10倍Cl-重量的HgSO4 掩蔽Cl-,加标(CODcr =100 mg/L)回收率为110%~120%左右,用30~40倍Cl -重量的HgSO4 掩蔽Cl-,加标回收率为100%左右,对HgSO4 掩蔽Cl-的条件和机理作了适当探讨.另外,采用加入H2 SO4-后加入HgSO4 的方法可减少HgSO4 的耗用量70%以上.     

臭氧+曝气生物滤池深度处理工艺试验研究

针对某污水厂出水不达标的情况,本研究采用臭氧(O3)和曝气生物滤池(BAF)组合工艺对其进行深度处理.结果表明,当采用两级臭氧+曝气生物滤池工艺时,出水COD在31～46 mg/L,色度在13～29倍,均达到一级A排放标准.在最佳运行条件下,臭氧氧化使相对分子质量大于50 000的有机物含量减少10％,小于1 000的有机物含量增加14％.曝气生物滤池工艺使相对分子质量小于1 000的有机物含量降低了24％.     

三江平原泥炭沼泽孔隙水甲烷浓度变化动态及其影响因子

湿地土壤孔隙水甲烷浓度变化动态对于揭示湿地碳循环过程具有重要作用.于2012年和2013年对三江平原毛苔草泥炭沼泽不同土壤深度孔隙水甲烷浓度的季节变化动态进行监测,并分析了其关键影响因子.结果表明:植物生长季孔隙水甲烷浓度呈单峰变化趋势,不同土层甲烷浓度峰值(80.45~490.95μmol·L-1)主要集中在湿润的生长季末,但年际间存在显著差异;从土壤剖面来看,土壤融通之后,孔隙水中甲烷浓度随着土壤深度的增加而增加;土壤表层(5 cm和10 cm)甲烷浓度主要受到株高(R2=0.6,p=0.005)和土壤充水孔隙率(R2=0.36,p=0.01)的影响,而深层(20~40 cm)甲烷浓度主要受到土壤温度等因素的综合影响.研究还表明,表层土壤孔隙水甲烷浓度能够解释生长季甲烷排放通量变化的26%~60%,而且短期的极端降雨事件可能不会对甲烷浓度以及甲烷排放产生即时影响,而是出现大约一周的延迟(time lag)现象,这主要取决于实际土壤湿度.     

污泥龄对低氧丝状菌活性污泥微膨胀系统的影响

为了研究污泥龄(SRT)对低氧丝状菌活性污泥微膨胀系统的影响,采用序批式间歇反应器(SBR)进行试验,分别按照厌氧/好氧和单级好氧的方式运行,考察了不同SRT下丝状菌污泥微膨胀系统的沉降性、脱氮除磷过程以及污泥特性的变化.结果表明,在好氧水力停留时间充分的条件下,低氧环境不但不会影响丝状菌微膨胀污泥的硝化进程,而且还有助于同步硝化反硝化(SND)、单级好氧除磷的发生.厌氧/好氧运行时,SRT与活性污泥的比硝化速率、比释磷速率和比吸磷速率成反比,与SND率和污泥的含磷量成正比.单级好氧运行时,减小SRT对硝化过程影响不大,但是有助于改善除磷效果.活性污泥的比耗氧速率(SOUR)、胞外聚合物(EPS)中多糖与蛋白质含量的比值、以及粘度都与SRT成反比.适当地减小SRT可以改善丝状菌微膨胀污泥的沉降性.厌氧/好氧运行时,厌氧段微氧环境易引发过度丝状菌污泥膨胀;单级好氧运行时,SRT过低会造成污泥黏性骤增而引发黏性污泥膨胀.